It is also a good idea to have a fire extinguisher present when working on the fuel system. Remove the fuel filler neck first. Once you determine the problem, a Delphi brand replacement fuel pump for the 1999-2003 Chevrolet Silverado 1500 can get you back up and running. Disconnect these plugs from the pump. Reconnect the fuel lines and lastly, reconnect the filler neck and tighten down the hose clamp and the vapor hose. This article applies to the Chevrolet Silverado 1500 2014-present.
Not even the Chevrolet dealership. This article will cover some of the most common. This article applies to the Chevrolet Silverado 1500 2014-present. If there is a problem, the truck is already in the air so you can double check your work. Step 2 — Locate the fuel filter and clean The fuel filter is located on the right frame rail near the fuel tank. For the rear strap, you'll need an assistant to hold the tank while you remove it.
Keep the truck in the air while you replace the fuel pump relay and start your truck. I have my truck back up and running. A novice with limited to no mechanical abilities can swap out a fuel pump in just a couple of hours at home. Does your Chevrolet Silverado feel like a different truck? We are covering a lot of them, so come on in. These steps will work for any 99 and up Silverado or Sierra. You trust your Chevrolet Silverado to be there for you when you need it,.
This article applies to the Chevrolet Silverado 1500 2014-present. Use a two wrench method when loosening fittings. There are two more lines above the vapor and supply lines that need to be disconnected as well. A guide identifying the relay is under the lid of the relay box. Install the new fuel pump onto the tank and secure with the locking ring.
To reduce risk of contaminating the replacement pump, Delphi recommends cleaning the fuel tank before installing a new pump. It might clear itself after driving for a bit, or you might have to clear it yourself. Take a close look at the new versus old electrical wiring harness on the top of the module and compare. These nuts are located on the backside of the frame rail. This article will walk you through the second method of dropping the fuel tank. Then you can fish it off of the top of the tank.
Step 1 — Relieve the pressure from the fuel system The fuel system is under constant pressure. Does your Chevrolet Silverado feel like a different truck? It is critical in keeping contaminants and particles from clogging injectors or other parts of the fuel system. Show it who's boss by getting rid of that idling problem. Replace the locking ring and turn it clockwise until it clicks back into position. Step 5 — Disconnect power lines to the fuel pump There are two quick release electrical plugs on top of the fuel tank that power the fuel pump. Is your engine acting roughly? It will drain more fuel when it's out, so go slow and keep as much in the tank as possible.
Do not smoke while working around fuel sources. Is your Chevrolet Silverado 1500. Disconnect the larger supply line next. If you suspect that you have a bad fuel pump or one that is nearing its end of life, don't get stranded, change the pump as soon as possible. They are connected with quick release clips. You will want to make sure that when you disconnect the lines, no dirt or debris gets into them. Parts for the truck are easy to come by, and many maintenance tasks are simple and straightforward.
Whatever you want to call it, don't let the sound persist in your Chevy Silverado. To loosen the bracket and remove the fuel filter, loosen the nuts that hold it into the mounting bracket. There is not much of. Solder them together and use shrink wrap over the spliced area. Like many pick-up trucks, the Silverado's fuel pump is within a module stored inside the fuel tank. This article applies to the Chevrolet Silverado 1999-2006. Then you need to make sure you have power back on the top of the fuel tank where the wiring connector hooks to the top of the fuel pump sending unit.